Allied-telesis AT-S62 Manual de usuario descargar pdf (Pagina 196)

100

101

Chapter 13: File System Commands

196

CREATE CONFIG

Syntax

create config=”filename.cfg”

Parameter

config Specifies the name of a new configuration file. If the

filename contains spaces, it must be enclosed in

double quotes. Otherwise, the quotes are optional.

Description

This command creates a new configuration file containing the

commands required to recreate the current configuration of the switch.

The CONFIG parameter specifies the name of the configuration file to

create. The file extension must be “.cfg”. If the file already exists, it is

replaced. If the file does not exist it is created.

The filename can be from 1 and 15 alphanumeric characters, not

including the “.cfg” extension. Spaces are allowed. Be sure to enclose the

name in double quotes if you include a space in the name. Wildcards are

not allowed.

This command does not change the assignment of the active boot

configuration file, which is the file the switch uses to configure itself the

next time it is reset or power cycled. To assign the new configuration file

as the active boot configuration file, refer to SET CONFIG on page 199.

Example

The following command creates the new configuration file Switch12.cfg.

The file will contain all of the commands necessary to recreate the

switch’s current configuration:

create config=Switch12.cfg

1 2 ... 191 192 193 194 195 196 197 198 199 200 201 ... 419 420

Comentarios a estos manuales

Sin comentarios

Allied-telesis AT-S62 Manual de usuario Pagina 196

Comentarios a estos manuales

Relacionado con productos y manuales para Hardware De La Computadora Allied-telesis AT-S62