Allied-telesis AT-S62 Manual de usuario Pagina 471

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 822
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 470
AT-S62 Management Software Menus Interface User’s Guide
Section III: SNMPv3 471
3. From the Configure SNMPv3 Community Table, type 3 to select Modify
SNMPv3 Table Entry.
The Modify SNMPv3 Community Table Menu is shown in Figure 149
on page 468.
4. To change the Storage Type, type 4 to select Set Storage Type.
The following prompt is displayed:
Enter Community Index:
5. Enter the Community Index of the Storage Type you want to change.
The following prompt is displayed:
Enter Storage type [V-volatile, N-NonVolatile]:
6. Select one of the following storage types for this table entry:
V - Volatile
Select this storage type if you do not want the ability to an entry in the
SNMPv3 Community Table to the configuration file. After making
changes to an SNMP Community Table entry with a Volatile storage
type, the S - Save Configuration Changes option does not appear on
the Main Menu.
N-NonVolatile
Select this storage type if you want the ability to save an entry in the
SNMPv3 Community Table to the configuration file. After making
changes to an SNMPv3 Community Table entry with a NonVolatile
storage type, the S - Save Configuration Changes option appears on
the Main Menu, allowing you to save your changes.
7. After making changes, type R until you return to the Main Menu. Then
type S to select Save Configuration Changes.
Vista de pagina 470
1 2 ... 466 467 468 469 470 471 472 473 474 475 476 ... 821 822

Comentarios a estos manuales

Sin comentarios