Allied-telesis AT-S62 Manual de usuario Pagina 205

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 822
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 204
AT-S62 Management Software Menus Interface User’s Guide
Section II: Advanced Operations 205
f. If you downloaded a new configuration file and you want to make it
the switch’s active boot file, go to “Setting the Active Boot
Configuration File” on page 179. If you downloaded a CA certificate
and want to add it to the certificate database, refer to “Adding a
Certificate to the Database” on page 722.
7. To download a file using Xmodem, type X at the prompt displayed in
Step 5.
The following prompt is displayed:
Local File Name:
8. Enter a name for the file. The file is given this name when stored in the
switch’s file system. When naming a file, be sure to give it an extension
that corresponds to its file type. The extensions and file types are listed
in Table 3 on page 204.
The following prompt is displayed:
You are going to invoke the Xmodem download utility.
Do you wish to continue? [Yes/No]
Note: Please select 1K Xmodem protocol for faster
download.
9. Type Y for Yes.
The prompt “Downloading” is displayed.
10. Begin the file transfer of the system file.
Note
The transfer protocol must be Xmodem or 1K Xmodem.
Steps 11 through 14 illustrate how to download a file with the Hilgraeve
HyperTerminal program.
11. From the HyperTerminal main window, select Send File from the
Transfer pull-down menu, as shown in Figure 52.
Figure 55. Local Management Window
Vista de pagina 204
1 2 ... 200 201 202 203 204 205 206 207 208 209 210 ... 821 822

Comentarios a estos manuales

Sin comentarios