Allied-telesis AT-S62 Manual de usuario Pagina 402

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 822
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 401
Chapter 21: SNMPv3
402 Section III: SNMPv3
2. From the Configure SNMPv3 Table Menu, type 3 to select Configure
SNMPv3 View Table.
The Configure SNMPv3 View Table Menu is shown in Figure 136 on
page 397.
3. From the Configure SNMPv3 View Table Menu, type 3 to select Modify
SNMPv3 Table Entry.
The Modify SNMPv3 Table Menu is shown in Figure 137 on page 400.
4. To modify the View Type, type 2 to select Set View Type.
The following prompt is displayed:
Enter View Name:
5. Enter a View Name that was previously configured.
The following prompt is displayed:
Enter View Subtree (OID format/Text Name):
6. Enter the View Subtree value for this View Name.
You can enter either a numeric value in hex format or the equivalent
text name. For example, the OID hex format for TCP/IP is:
1.3.6.1.2.1.6
The text format is for TCP/IP is:
tcp
The following prompt is displayed:
Enter View Type [I-Included, E-Excluded]:
7. Choose one of the following view types:
I - Included
Enter this value to permit the View Name to see the subtree specified
above.
E - Excluded
Enter this value to not permit the View Name to see the subtree
specified above.
8. After making changes, type R until you return to the Main Menu. Then
type S to select Save Configuration Changes.
Vista de pagina 401
1 2 ... 397 398 399 400 401 402 403 404 405 406 407 ... 821 822

Comentarios a estos manuales

Sin comentarios