76
3. Type 1 to select Trunk Ports.
The following prompt is displayed.
Enter Trunk Port(s) ->
4. Enter the ports that will constitute the port trunk and press Return.
You can specify the ports individually (e.g., 1,2,3,4) or as a range
(e.g., 7-10).
5. Type S to select Save Configuration Changes.
6. Configure the ports on the remote end node for port trunking. Refer
to the instructions included with the node for directions on how to
create a port trunk.
7. Connect the cables to the ports of the trunk on the switch.
The port trunk is ready for network operations.
Comentarios a estos manuales