Allied-telesis AT-S39 Manual de usuario Pagina 205

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 242
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 204
AT-S39 Users Guide
205
Configuring a Bridge or Ports STP Settings
Caution
STP on a bridge is disabled by default. If you enable STP, the bridge
provides default STP parameters that are adequate for most
networks. Changing them without prior experience and an
understanding of how STP works might have a negative effect on
your network. You should consult the IEEE 802.1d standard before
changing any of the STP parameters.
To configure a bridge or ports STP parameters, perform the following
procedure:
1. From the Home page, select Configuration.
2. From the Configuration menu, select Layer 2.
3. From the Layer 2 window, select the Spanning Tree tab.
The Spanning Tree window in Figure 65 is displayed.
Figure 65 Spanning Tree Protocol Window - Bridge Configuration
Vista de pagina 204
1 2 ... 200 201 202 203 204 205 206 207 208 209 210 ... 241 242

Comentarios a estos manuales

Sin comentarios