Allied-telesis AT-S39 Manual de usuario Pagina 183

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 242
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 182
AT-S39 Users Guide
183
This window is for viewing purposes only. You cannot change any
of the values from this window. The sections in the window are
defined below.
General
This section displays the switchs serial number and the switchs
MAC address. These values cannot be changed.
Administration
This section contains a variety of information, including the IP
address of the switch and the system name. These parameters are
defined in the procedure Configuring an IP Address and Switch
Name on page 177, which also explains how to change the
parameters.
Configuration
This section contains the following items:
MAC Aging - Specifies how long an inactive dynamic MAC address
can remain in the MAC address table before it is deleted. The
default is 300 seconds (5 minutes). For background information
about MAC addresses, refer to MAC Address Overview on page
128.
Switch Mode - Defines the switchs current VLAN mode. If this
parameter displays Tagged, the switch supports port-based and
tagged VLANs. If this parameter displays Basic, the switch is
operating in the Basic VLAN Mode. For information about VLANs,
refer to the overview sections in Chapter 10, Virtual LANs on
page 90. For instructions on how to set the switchs VLAN mode
from a web browser management session, refer to Setting a
Switchs VLAN Mode on page 122.
BOOTP/DHCP - Defines whether the switch obtains its IP address
from a BOOTP or DHCP server on your network. If this parameter
is enabled, the switch obtains its IP address from a BOOTP or
DHCP server.
Vista de pagina 182
1 2 ... 178 179 180 181 182 183 184 185 186 187 188 ... 241 242

Comentarios a estos manuales

Sin comentarios