Allied-telesis AT-S39 Manual de usuario descargar pdf (Pagina 24)

Section II: Local or Telnet Management

Local Management Session

On the front panel of the switch is a port labelled RS232 Terminal Port.

You use this port to establish a local management session with the

switch’s AT-S39 management software.

A local management session is so named because you must be close to

the switch, usually within a few meters, to start this type of management

session. This typically means that you must be in the wiring closet where

the switch is located.

A switch does not need an IP address to be managed from a local

management session. You can start a local management session at any

time on any AT-8024, AT-8024GB, or AT-8026FC switch in your network.

Additionally, running a local management session does not interfere

with the flow of Ethernet traffic through the unit.

Starting a local management session on a switch that has been

configured as a Master switch of an enhanced stack allows you to

manage all the switches in the subnet from the same local management

session. You do not have to start a separate local management session

for each switch. This can simplify network management.

Starting a local management session on a switch that is not part of an

enhanced stack or that is a slave switch in an enhanced stack allows you

to manage just that switch.

Note

For information on enhanced stacking, refer to Enhanced Stacking

Overview on page 47.

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 241 242

Sin comentarios

Allied-telesis AT-S39 Manual de usuario Pagina 24