Allied-telesis AT-MCF2300 Manual de usuario descargar pdf (Pagina 79)

AT-MCF2000 Media Converter Series Installation Guide

Section I: Features 79

Chassis ID Numbers

To be a member of a stack, a chassis must have a unique chassis ID

number in the range of 0 to 31. (There is no relationship between the

chassis ID range and the maximum number of units in a stack.). You use

the numbers to identify the units when managing them with the

management software.

The ID numbers are assigned with the AT-MCF2000M Management

Module and the AT-MCF2000S Stacking Module. The chassis ID number

on the AT-MCF2000M Management Module can be either 0 or 31 and is

set with a jumper. The default value is 0. The only reason you might

change the jumper is if there will be two management cards in the stack

and you want to assign the second management card the value 31.

Otherwise, there is no reason to change the chassis ID number of a

management card from the default value of 0.

Note

At the time this manual was published, the AT-S97 Management

Software did not support two management cards in a stack. For the

latest information, refer to the Software Release Notes.

Figure 39. Chassis ID Jumper on the AT-MCF2000M Management

Module

The ID number for the AT-MCF2000S Stacking Module has a range of 1 to

30 and is set with DIP switches. The default value is 1. The settings are

provided in Table 35 on page 179 and Table 36 on page 180, and in the

table printed on the module.

-MCF2000M

ACKM

AGEM

TER

INA

-T

RS-232

RESET

ASTER

OWER

T A

CTIVITY

1416

Chassis ID 0

(Default)

Chassis ID 31

Chassis ID Jumper

1 2 ... 74 75 76 77 78 79 80 81 82 83 84 ... 189 190

Comentarios a estos manuales

Sin comentarios

Allied-telesis AT-MCF2300 Manual de usuario Pagina 79

Comentarios a estos manuales

Relacionado con productos y manuales para Hardware De La Computadora Allied-telesis AT-MCF2300