Allied-telesis AT-MCF2300 Manual de usuario descargar pdf (Pagina 123)

Section II: Installation 123

Chapter 16

Grounding the AT-MCF2300 Chassis

If you installed the AT-MCF2300 Chassis in an equipment rack, perform

this procedure to ground the unit. This procedure requires these items:

 Phillips head No. 2 screwdriver

 10 AWG solid wire (The length of the wire will depend on your

installation.)

 Crimping tool

 Grounding lug (included with the chassis)

To ground the AT-MCF2300 Chassis:

1. Strip the grounding wire as shown in Figure 68.

Figure 68. Stripping the Grounding Wire

2. Use a crimping tool to attach the wire to the grounding lug included

with the chassis.

Figure 69. Attaching the Grounding Wire to the Grounding Lug

3. Remove the two grounding lug screws from the lower left corner on the

back panel of the chassis.

11mm ±1mm

(0.44in. ±0.03in.)

100

102

1 2 ... 118 119 120 121 122 123 124 125 126 127 128 ... 189 190

Sin comentarios

Allied-telesis AT-MCF2300 Manual de usuario Pagina 123