Allied-telesis AT-MCF2300 Manual de usuario descargar pdf (Pagina 142)

Chapter 21: Verifying the Installation

142 Section II: Installation

AT-MCF2000M Management Module

To verify the installation of the optional AT-MCF2000M Management

Module:

❒ Verify that the Power LED on the module is green.

❒ Verify that the System LED is steady or flashing green.

❒ If the 10/100/1000Base-T Management port is connected to a network

device, check that the port’s L/A (Link/Activity) LED is steady or

flashing green or amber.

❒ If the Stack port is connected to another chassis, verify that the L/A

(Link/Activity) LED for the port is steady or flashing green.

If you encounter any problems, refer to “AT-MCF2000M Management

Module” on page 153.

AT-MCF2000S Stacking Module

To verify the installation of the optional AT-MCF2000S Stacking Module:

❒ View the Chassis ID LEDs to determine the modules number

assignment, set with the DIP switches. If, when you installed the

module, you affixed a label with the module’s ID number to its

faceplate, compare the number on the Chassis ID LEDs with the

number on the label. They should be the same. If they are not, remove

the module and reset the DIP switches.

❒ If the Stack ports are connected to other units, verify that the Link/

Activity LEDs for the ports are steady or flashing green.

If you encounter any problems, refer to “AT-MCF2000S Stacking Module”

on page 155.

1 2 ... 137 138 139 140 141 142 143 144 145 146 147 ... 189 190

Sin comentarios

Allied-telesis AT-MCF2300 Manual de usuario Pagina 142