Allied-telesis AT-S97 Manual de usuario descargar pdf (Pagina 90)

Chapter 6: Port and Module Commands

port Specifies the letter of a port in a

channel on a media converter

module. Possible values are:

a Specifies a twisted pair port. If

you specify only a port and not

a channel, then all of the

twisted pair ports are specified.

b Specifies a fiber optic port. If

you specify only a port and not

a channel, then all of the fiber

ports are specified.

To view the ID and slot numbers of a chassis, refer to

“SYSTEM SHOW CLUSTER” on page 99 or “SYSTEM

SHOW CHASSIS” on page 96. To view the ports of a

channel, refer to “SYSTEM SHOW INTERFACE” on

page 101.

port-state Enables and disables the port. Available settings are:

enable Activates the transmitter and receiver on the

port. This is the default setting.

disable Deactivates the transmitter and receiver on the

port.

auto-neg Activates and deactivates IEEE 802.3u Auto-Negotiation

and auto-MDI/MDIX on a port. When Auto-Negotiation is

activated, the port’s speed, duplex mode, and wiring

configuration are set automatically. Available settings are:

enable Activates IEEE 802.3u Auto-Negotiation and

auto-MDI/MDIX on the port. This is the default

setting for a twisted pair port. This is also the

default setting for fiber optic ports that support

Auto-Negotiation, such as 100Base-SX ports.

This setting is not appropriate for fiber optic

ports that do not support Auto-Negotiation, such

as 100Base-FX and 1000Base-F.

disable Deactivates IEEE 802.3u Auto-Negotiation and

auto-MDI/MDIX on the port.

speed Sets the speed of a twisted pair port. Available settings are:

10 Sets the speed of the port to 10 Mbps.

100 Sets the speed of the port to 100 Mbps.

1 2 ... 85 86 87 88 89 90 91 92 93 94 95 ... 253 254

Sin comentarios

Allied-telesis AT-S97 Manual de usuario Pagina 90