Allied-telesis AT-S97 Manual de usuario descargar pdf (Pagina 163)

AT-S85 and AT-S97 Management Software Command Line Interface User’s Guide

163

Figure 35. CONFIG SHOW Command with a New Active Master File

If you were to issue the CONFIG SAVE command at this point, the settings

in the “mcf24.cfg” file would be overwritten by the current settings of the

modules. Basically, the settings in the active configuration file would be

replaced by the settings of the master configuration file used during the

last reset, in this case “unit12.cfg,” in addition to any changes that were

make since the last reset or power cycle. And, in some situations, this

might be the goal.

But if the goal is to configure the modules with the settings in “mcf24.cfg,”

you issue the CONFIG RUN command so that the management module

configures the modules with the settings in the file. If, after issuing the

CONFIG RUN command, you again entered the CONFIG SHOW

command, the information in Figure 36 is displayed.

Figure 36. CONFIG SHOW Command with a New Current and Active

Master File

Example

The following command displays the names of the current and active

master configuration files on the management module:

config show

Last configuration file ran ............. unit12.cfg

Current set configuration file .......... mcf24.cfg (Exists)

Last configuration file ran ............. mcf24.cfg

Current set configuration file .......... mcf24.cfg (Exists)

1 2 ... 158 159 160 161 162 163 164 165 166 167 168 ... 253 254

Sin comentarios

Allied-telesis AT-S97 Manual de usuario Pagina 163