Allied-telesis AT-S97 Manual de usuario descargar pdf (Pagina 102)

Chapter 6: Port and Module Commands

102

Privilege Levels

Administrator, read-write, and read-only.

General Description

This command can display a variety of status information about a media

converter chassis and the media converter modules. You can limit the

information to just the model names of the media converter modules in a

chassis or view more detailed information about the devices, such as the

current operating parameters of the two ports of a media converter

channel.

Note

To view the parameter settings of the 10/100/1000Base-T port on

the AT-MCF2000M Management Module, use the SYSTEM SHOW

MODULE command. For information, refer to “SYSTEM SHOW

MODULE” on page 108.)

Description of the Chassis Only Command

Specifying just a chassis ID number in the command displays the names

of the media converter models in a chassis and their respective slot

numbers. This is useful in determining the types of media converter

modules in a chassis. An example of the information is shown in

Figure 13.

Figure 13. SYSTEM SHOW INTERFACE Command - Chassis ID Only

The table does not include empty media converter slots. The columns in

the table are defined here:

 Chassis ID - The chassis ID number.

 Slot ID - The slot numbers of the media converter modules in the

chassis. In the AT-MCF2000 Chassis, the left slot is 1 and the right slot

is 2.

 Module Name - The module’s name. To assign a name, refer to

“SYSTEM SET MODULE” on page 86.

 Module Type - The module’s model name.

Interface 0 Information:

Chassis ID Slot ID Module Name Module Type

----------------------------------------------------

1 1 Traffic 12 AT-MCF2012LC

1 2 Traffic 7 AT-MCF2012LC

1 2 ... 97 98 99 100 101 102 103 104 105 106 107 ... 253 254

Sin comentarios

Allied-telesis AT-S97 Manual de usuario Pagina 102