Allied-telesis AT-S62 Manual de usuario Pagina 679

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 862
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 678
AT-S62 User’s Guide
Section VIII: Web Browser Management 679
Configuring the SNMPv3 Protocol
To configure the SNMPv3 protocol, you need to configure the SNMPv3
tables. To enable a manager to access the SNMPv3 protocol on the
switch, you need to enable the SNMP protocol. See the following
procedures:
Enabling the SNMP Protocol on page 680
Configuring the SNMPv3 User Table on page 683
Configuring the SNMPv3 View Table on page 690
Configuring the SNMPv3 Access Table on page 696
Configuring the SNMPv3 SecurityToGroup Table on page 703
Configuring the SNMPv3 Notify Table on page 708
Configuring the SNMPv3 Target Address Table on page 713
Configuring the SNMPv3 Target Parameters Table on page 720
Configuring the SNMPv3 Community Table on page 727
Note
Use the SNMPv3 Community Table only if you are configuring the
SNMPv3 protocol with the SNMPv1 or an SNMPv2c protocol. Allied
Telesyn does not recommend this configuration.
For reference information about the SNMPv3 protocol, see Chapter 17:
SNMPv3 Configuration on page 222.
Vista de pagina 678
1 2 ... 674 675 676 677 678 679 680 681 682 683 684 ... 861 862

Comentarios a estos manuales

Sin comentarios