Allied-telesis AT-S62 Manual de usuario Pagina 42

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 862
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 41
Chapter 2: Starting a Local or Telnet Management Session
Section I: Basic Operations 42
Starting a Local
Management
Session
To start a local management session, perform the following procedure:
1. Connect one end of the straight-through RS232 management cable
to the RS232 Terminal Port on the front panel of the switch.
Figure 1 Connecting a Terminal or PC to the RS232 Terminal Port
2. Connect the other end of the cable to an RS-232 port on a terminal or
PC with a terminal emulator program.
3. Configure the terminal or terminal emulator program as follows:
Baud rate: 9600 bps
Data bits: 8
Parity None
Stop bits: 1
Flow control: None
Note
The port settings are for a DEC VT100 or ANSI terminal, or an
equivalent terminal emulator program.
Note
During boot up, the switch displays the following prompt: Press
<CTRL>B to go to Boot Prompt. This message is intended
for manufacturing purposes only. (If you inadvertently display the
boot prompt (=>), type boot and press Return to start the switch.)
FAULT
RPS
MASTER
PWR
STATUS
AT-8524M
Fast Ethernet Switch
COL
100
FULL
ACT
MODE
Vista de pagina 41
1 2 ... 37 38 39 40 41 42 43 44 45 46 47 ... 861 862

Comentarios a estos manuales

Sin comentarios