Allied-telesis AT-S62 Manual de usuario descargar pdf (Pagina 377)

100

101

AT-S62 User’s Guide

Section IV: Spanning Tree Protocols 377

Associating VLANs to MSTI IDs

When you create a new MSTI ID, you are given the opportunity of

associating VLANs to it. But, once a MSTI ID is created, there might come

a time when you want to add more VLANs to it, or perhaps remove

VLANs. This procedure explains how to associate VLANs on the switch to

an existing MSTI ID and also how to remove VLANs. Before performing

this procedure, note the following:

❑ You must create a MSTI ID before you can assign VLANs to it. To

create a MSTI ID, refer to Creating, Deleting, and Modifying MSTI

IDs on page 374.

❑ You can assign a VLAN to only one MSTI. By default, a VLAN, when

created, is associated with the CIST instance, which has a MSTI ID

of 0.

❑ An MSTI can contain any number of VLANs.

Note

You cannot configure MSTP parameters until you have selected the

protocol as the active spanning tree protocol on the switch. For

instructions, refer to Enabling or Disabling a Spanning Tree Protocol

on page 340.

This procedure starts from the MSTP Menu. If you do not know how to

access the menu, perform steps 1 and 2 in Configuring MSTP Bridge

Settings on page 369.

To add or remove a VLAN from an MSTI ID, do the following:

1. From the MSTP Menu, type V to select VLAN-MSTI Association Menu.

1 2 ... 372 373 374 375 376 377 378 379 380 381 382 ... 861 862

Comentarios a estos manuales

Sin comentarios

Allied-telesis AT-S62 Manual de usuario Pagina 377

Comentarios a estos manuales

Relacionado con productos y manuales para Hardware De La Computadora Allied-telesis AT-S62