Allied-telesis AlliedView-EMS 3.11 DEVICE MANAGEMENT Manual de usuario descargar pdf (Pagina 183)

AlliedView™-EMS 3.11 Device Management Guide Page 183 of 402

Policies

Displays Policy parameters.

Note - The current firmware version accepts up to 32 characters for the Description

parameter. NULL values are not allowed.

Note - The Redirect Port parameter is cleared of its value each time the switch is

restarted.

Note - The current firmware version does not allow the Ingress Port List and Egress

Port List parameters to be set to NULL.

Enable

Enables the port.

Disable

Disables the port.

Port Mirroring

Displays Port Mirroring parameters and allows you to create/delete a port mirror.

Note - The Mirroring Source Module, Mirroring Source Port and Mirroring

Destination Module parameters are not applicable to the AT-8500 series and should

be ignored.

Note - Setting the Port Mirroring Status parameter to 'enabled' without setting the

Mirroring Destination Port parameter to a valid value first will result in the error

message "The error occurred with 'Set' operation. Error: gen Error". However, the

value 'enabled' is still set successfully.

Note - The current firmware version does not allow the Mirroring Destination Port

parameter to be set to 0.

Note - The current firmware version does not allow the Mirroring Source Port

(Ingress) and Mirroring Source Port (Egress) parameters to be set to NULL.

Note - The current firmware version does not allow the Port Mirroring Status

parameter to be set to 'enabled' if, upon device startup, the Port Mirroring feature is

disabled.

MAC Address Security

Displays MAC Address Security parameters and allows you to set the security level

for dynamic and static MAC addresses learned and assigned to a port.

Intrusion Attack

Displays the VLAN ID and the MAC Address of each port.

1 2 ... 178 179 180 181 182 183 184 185 186 187 188 ... 401 402

Sin comentarios

Allied-telesis AlliedView-EMS 3.11 DEVICE MANAGEMENT Manual de usuario Pagina 183