Allied-telesis AT-WL2411 Manual de usuario Pagina 193

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 236
  • Tabla de contenidos
  • SOLUCIÓN DE PROBLEMAS
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 192
AT-WL2411 Version 1.80 Installation and User’s Guide
193
Using Test Mode Commands
Within the access point monitor, test mode allows you to perform
certain test functions. Because the commands can cause undesirable
results if not properly executed, you should contact Allied Telesyn
Technical Support for assistance if you are unsure about the proper
procedure to use. Refer to Contacting Allied Telesyn Technical Support
on page 15 for information.
TEST Purpose
Allows you to enter test mode where you can perform a variety of test
functions.
Syntax
TEST
To enter test mode, perform the following procedure:
1. Type Test and press <Enter>.
2. Enter a password. The default password is EV98203T (case sensitive).
When you are in test mode, the test prompt (test>) appears. Test mode
has a set of defined commands that you can use.
Vista de pagina 192
1 2 ... 188 189 190 191 192 193 194 195 196 197 198 ... 235 236

Comentarios a estos manuales

Sin comentarios