Allied-telesis AT-S95 CLI (AT-8000GS Series) Manual de usuario Pagina 149

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 397
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 148
IPv6 Addressing Commands
Page 149
Chapter 12.IPv6 Addressing Commands
ipv6 enable
The ipv6 enable Interface Configuration mode command enables IPv6 processing on an interface. Use the no
form of this command to disable IPv6 processing on an interface.
Syntax
ipv6 enable [no-autoconfig]
no ipv6 enable
Parameters
no-autoconfig — Enables IPv6 processing on an interface without the stateless address autoconfiguration
procedure.
Default Configuration
IPv6 is disabled.
Command Mode
Interface Configuration (VLAN) mode.
User Guidelines
The ipv6 enable command automatically configures an IPv6 link-local unicast address on the interface while also
enabling the interface for IPv6 processing. The no ipv6 enable command removes the entire IPv6 interface
configuration.
Example
The following example enables IPv6 processing on VLAN 1.
ipv6 address
The ipv6 address Interface Configuration mode command sets an IPV6 address. Use the no form of this
command to remove an IPV6 address from the interface.
Syntax
ipv6 address ipv6-address/prefix-length [eui-64] [anycast]
no ipv6 address [ipv6-address/prefix-length] [eui-64]
console(config)# interface vlan 1
console(config-if)# ipv6 enable
Vista de pagina 148
1 2 ... 144 145 146 147 148 149 150 151 152 153 154 ... 396 397

Comentarios a estos manuales

Sin comentarios