Allied-telesis AT-S95 CLI (AT-8000GS Series) Manual de usuario descargar pdf (Pagina 133)

IGMP Snooping Commands

Page 133

used for setting the aging-out time after Multicast device ports are automatically learned. Use the no form of this

command to return to the default configuration.

Syntax

ip igmp snooping mrouter-time-out time-out

no ip igmp snooping mrouter-time-out

Parameters

•

time-out — Multicast device timeout in seconds (Range: 1 - 2147483647)

Default Configuration

The default value is 300 seconds.

Command Mode

Interface Configuration (VLAN) mode

User Guidelines

There are no user guidelines for this command.

Example

The following example configures the Multicast device timeout to 200 seconds.

ip igmp snooping leave-time-out

The ip igmp snooping leave-time-out Interface Configuration (VLAN) mode command configures the leave-

time-out. If an IGMP report for a Multicast group was not received for a leave-time-out period after an IGMP Leave

was received from a specific port, this port is deleted from the member list of that Multicast group. Use the no form

of this command to return to the default configuration.

Syntax

ip igmp snooping leave-time-out {time-out | immediate-leave}

no ip igmp snooping leave-time-out

Parameters

•

time-out — Specifies the leave-time-out in seconds for IGMP queries. (Range: 0 - 2147483647)

• immediate-leave — Indicates that the port should be immediately removed from the members list after

receiving IGMP Leave.

Default Configuration

The default leave-time-out configuration is 10 seconds.

console(config)#

interface vlan

console(config-if)#

ip igmp snooping mrouter-time-out

200

1 2 ... 128 129 130 131 132 133 134 135 136 137 138 ... 396 397

Sin comentarios

Allied-telesis AT-S95 CLI (AT-8000GS Series) Manual de usuario Pagina 133