Allied Telesis Switch AT-9000/28 Manual de usuario descargar pdf (Pagina 212)

Chapter 18: Setting LLDP and LLDP-MED

212

 Non Strict Med TLV Order Check— Sets the switch to accept

LLDP-MED advertisements even if the TLVs are not in the

standard order, as specified in ANSI/TIA-1057. This configuration

is useful if the switch is connected to devices that send LLDP-MED

advertisements in which the TLVs are not in the standard order.

Click in the box next to this field to select the nonstrict Med TLV

Order Check.

 Notification Interval— Sets the notification interval. This is the

minimum interval between LLDP SNMP notifications (traps). The

range is 5 to 3,600 seconds.

 Reinit— Sets the reinitialization delay. This is the number of

seconds that must elapse after LLDP is disabled on a port before it

can be reinitialized. The range is 1 to 10 seconds.

 Tx Delay— Specifies the transmission delay. This is the minimum

time interval between transmissions of advertisements due to

changes in LLDP local information.

 Total Neighbors— Indicates the number of LLDP neighbors the

switch has discovered on all its ports. You cannot modify this field.

 Neighbors Last Update— Indicates the time since the LLDP

neighbor table was last updated. You cannot modify this field.

5.Click Apply.

Setting LLDP

Port Assignments

To assign LLDP to a port, do the following:

1. Select the Discovery & Monitoring tab.

The Discovery & Monitoring tab is displayed. See Figure 68 on page

201.

2. From the Discovery & Monitoring tab, select LLDP and then select

Port Configurations.

1 2 ... 207 208 209 210 211 212 213 214 215 216 217 ... 247 248

Sin comentarios

Allied Telesis Switch AT-9000/28 Manual de usuario Pagina 212