Allied-telesis x600-48Ts/XP Manual de usuario descargar pdf (Pagina 74)

Chapter 4: Cabling the Network Ports

Powering on a Switch

To power on a switch, perform the following procedure:

1. Position the power cord retaining clip in the up position, as shown in

Figure 38.

Figure 38. Power Cord Retaining Clip in the Up Position

2. Plug the power cord into the AC power connector on the rear panel of

the unit (see Figure 39).

Figure 39. Connecting the AC Power Cord

3. Connect the other end of the power cord to an appropriate AC power

outlet. For power specifications for the switch, refer to “Power

Specifications” on page 88.

Warning: Power cord is used as a disconnection device. To de-

energize equipment, disconnect the power cord.



100-240VAC

1 2 ... 69 70 71 72 73 74 75 76 77 78 79 ... 93 94

Installation Guide 1
Product Documentation 4
Starting a Management Session 5
Contacting Allied Telesis 8
Radiated Energy 9
Industry Canada 9
Translated Safety Statements 10
Contents 11
List of Figures 13
List of Tables 15
Overview 17
Introduction 18
Switch Descriptions 19
Connector 20
AC Power 20
RPS Connector 22
Distance 23
Auto-MDI/ 24
SFP Transceiver Slots 25
XFP Transceiver Slots 26
Redundant Twisted Pair Ports 27
SD Card Slot 28
Port LEDs 29
XFP Transceiver 30
Slot LEDs 30
System Status LEDs 31
Stack LEDs 32
Terminal Port 34
AT-LBM (Loop Back) Module 36
RPS INPUT 36
100-240VAC~ 36
VCS Stacking Module 37
AT-StackXG 37
STACK PORT 1 37
STACK PORT 2 37
AC Power Connector 38
Virtual Chassis Stacking 39
Introduction 40
uses two switches that are 41
Recovery States 42
Resiliency Link 44
Configurations 44
Resilient Stacked 45
Topology 45
Stack Formation 46
Selecting the Stack Master 46
Common Stack Configuration 47
Stack Management VLAN 47
Stack Member Identification 48
Management IP Addresses 49
Fallback Action 50
Re-elect New Stack Master 50
Recombining Separated Stacks 50
Adding a Stack Member 51
Replacing a Stack Member 51
Repairing a Broken Stub 51
Installing the Hardware 53
Reviewing Safety Precautions 54
Unpacking a Switch 56
100-240VAC 57
Resetting the Switch 60
Installing the 62
Cabling the Network Ports 65
Twisted Pair 66
Specifications 66
Transceiver 67
Installing an SFP 68
SFP Handle 69
4741 43 45 70
42 44 46 70
Installing an XFP 71
Powering on a Switch 74
Starting a Local 75
Management 75
Warranty Registration 76
Troubleshooting 77
Power LED is Off 78
SFP or XFP LED is Off 80
System Fault LED is Blinking 82
Chapter 5: Troubleshooting 84
Technical Specifications 87
Power Specifications 88
Certifications 88

Comentarios a estos manuales

Sin comentarios

Allied-telesis x600-48Ts/XP Manual de usuario Pagina 74

Comentarios a estos manuales

Relacionado con productos y manuales para Hardware De La Computadora Allied-telesis x600-48Ts/XP