Allied-telesis x600-48Ts/XP Manual de usuario descargar pdf (Pagina 35)

x600 Series Layer 3 Gigabit Ethernet Switches Installation Guide

AT-RPS3204 Redundant Power Supply

The RPS connector on the rear panel of the switch connects to the

optional AT-RPS3204 Redundant Power Supply module, shown in Figure

12. The unit can provide power to the switch in the event that the switch’s

internal power supply fails.

The AT-RPS3204 Redundant Power Supply module features one pre

installed AT-PWR3202 Power Supply and three empty slots for additional

power supplies. Each power supply can support one x600 switch. When

fully populated with AT-PWR3202 Power Supplies, the AT-RPS3204 unit

can support up to four x600 switches simultaneously.

The AT-RPS3204 Redundant Power Supply module is hot swappable with

the x600 switches. This means that it is safe to connect a powered on AT-

RPS3204 module to an x600 switch (which is also powered on) using a

21-pin D-combo connector cable from the module into the RPS connector

on the x600 switch.

For information about installing an AT-RPS3204 unit, consult the

documentation shipped with the unit.

Figure 12. AT-RPS3204 Redundant Power Supply Unit

The pinouts for the redundant power supply’s 21-pin D-combo port and

connector are described in “RPS 21-pin D-combo Port and Connector

Pinouts” on page 92.

T- P

R3204

POWER

1 2 ... 30 31 32 33 34 35 36 37 38 39 40 ... 93 94

Sin comentarios

Allied-telesis x600-48Ts/XP Manual de usuario Pagina 35