Allied-telesis x600-48Ts/XP Manual de usuario Pagina 23
- Pagina / 94
- Tabla de contenidos
- SOLUCIÓN DE PROBLEMAS
- MARCADORES
Valorado. / 5. Basado en revisión del cliente
x600 Series Layer 3 Gigabit Ethernet Switches Installation Guide
23
10/100/1000Base-T Twisted Pair Ports
This section describes the twisted pair ports on the switches.
Connector Type The ports are 8-pin RJ-45 connectors that use four pins at 10 or 100 Mbps
and all eight pins at 1000 Mbps. For the pin assignments, refer to “RJ-45
Twisted Pair Port Pinouts” on page 89.
Speed A port’s speed can be 10, 100, or 1000 Mbps. The speed can be set
automatically through Auto-Negotiation, the default setting, or manually
with the AlliedWare Plus
Operating System Software.
Duplex Mode A twisted pair port can operate in either half- or full-duplex mode. (Full-
duplex mode is the only mode available when a port is operating at 1000
Mbps.) The twisted pair ports are IEEE 802.3u-compliant and Auto-
Negotiate the duplex mode setting.
You can disable Auto-Negotiation on one or all of the switch ports so that
you can set the duplex mode manually through the AlliedWare Plus
Operating System Software.
Note
In order for a switch port to successfully Auto-Negotiate its duplex
mode with a 10 or 100 Mbps end node, the end node must be
configured for Auto-Negotiation. Otherwise, a duplex mode
mismatch can occur. A switch port using Auto-Negotiation defaults
to half-duplex if it detects that the end node is not using Auto-
Negotiation. This results in a mismatch if the end node is operating
at a fixed duplex mode of full-duplex.
To avoid this problem when connecting an end node with a fixed
duplex mode of full-duplex to a switch port, use the AlliedWare Plus
Operating System Software to disable Auto-Negotiation on the port
and set the port speed and duplex mode manually.
Please be aware that disabling Auto-Negotiation will also disable
Auto-MDI/MDIX and the port’s wiring configuration defaults to the
MDI-X setting. This setting can be configured with the AlliedWare
Plus
Operating System Software.
Maximum
Distance
The ports have a maximum operating distance of 100 meters (328 feet).
- Installation Guide 1
- Product Documentation 4
- Starting a Management Session 5
- Contacting Allied Telesis 8
- Radiated Energy 9
- Industry Canada 9
- Translated Safety Statements 10
- Contents 11
- List of Figures 13
- List of Tables 15
- Overview 17
- Introduction 18
- Switch Descriptions 19
- Connector 20
- AC Power 20
- RPS Connector 22
- Distance 23
- Auto-MDI/ 24
- SFP Transceiver Slots 25
- XFP Transceiver Slots 26
- Redundant Twisted Pair Ports 27
- SD Card Slot 28
- Port LEDs 29
- XFP Transceiver 30
- Slot LEDs 30
- System Status LEDs 31
- Stack LEDs 32
- Terminal Port 34
- AT-LBM (Loop Back) Module 36
- RPS INPUT 36
- 100-240VAC~ 36
- VCS Stacking Module 37
- AT-StackXG 37
- STACK PORT 1 37
- STACK PORT 2 37
- AC Power Connector 38
- Virtual Chassis Stacking 39
- Introduction 40
- uses two switches that are 41
- Recovery States 42
- Resiliency Link 44
- Configurations 44
- Resilient Stacked 45
- Topology 45
- Stack Formation 46
- Selecting the Stack Master 46
- Common Stack Configuration 47
- Stack Management VLAN 47
- Stack Member Identification 48
- Management IP Addresses 49
- Fallback Action 50
- Re-elect New Stack Master 50
- Recombining Separated Stacks 50
- Adding a Stack Member 51
- Replacing a Stack Member 51
- Repairing a Broken Stub 51
- Installing the Hardware 53
- Reviewing Safety Precautions 54
- Unpacking a Switch 56
- 100-240VAC 57
- Resetting the Switch 60
- Installing the 62
- Cabling the Network Ports 65
- Twisted Pair 66
- Specifications 66
- Transceiver 67
- Installing an SFP 68
- SFP Handle 69
- 4741 43 45 70
- 42 44 46 70
- Installing an XFP 71
- Powering on a Switch 74
- Starting a Local 75
- Management 75
- Warranty Registration 76
- Troubleshooting 77
- Power LED is Off 78
- SFP or XFP LED is Off 80
- System Fault LED is Blinking 82
- Chapter 5: Troubleshooting 84
- Technical Specifications 87
- Power Specifications 88
- Certifications 88
Relacionado con productos y manuales para Hardware De La Computadora Allied-telesis x600-48Ts/XP
Hardware De La Computadora Allied-telesis AlliedView-EMS 4.0.2 Device-Manager Manual de usuario
(441 paginas)
(441 paginas)
Hardware De La Computadora Allied-telesis AT-9448Ts/XP (Basic Layer 3) Manual de usuario
(108 paginas)
(108 paginas)
Hardware De La Computadora Allied-telesis AlliedView-EMS 4.0.1 INSTALLATION Manual de usuario
(32 paginas)
(32 paginas)
Hardware De La Computadora Allied-telesis AlliedView-EMS 4.0.1 VLAN MANAGER Manual de usuario
(72 paginas)
(72 paginas)
Hardware De La Computadora Allied-telesis AT-9448Ts/XP (Basic Layer 3) Manual de usuario
(106 paginas)
(106 paginas)
Hardware De La Computadora Allied-telesis AlliedView-EMS 4.0.1 QoS MANAGER Manual de usuario
(146 paginas)
(146 paginas)
© 2020, manymanuals.es. Todos los derechos reservados | 0.064 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentarios a estos manuales