Allied-telesis SwitchBlade x3112 Manual de usuario Pagina 80

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 222
  • Tabla de contenidos
  • SOLUCIÓN DE PROBLEMAS
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 79
Chapter 3: Installing the Chassis in an Equipment Rack
80
Figure 34. Reserving Vertical Rack Space
3. Identify the lowest 1/2” screw hole pattern on the rack mounting rails
within the space reserved for the AT-SBx3112 Chassis.
4. Install one rack mount screw in each vertical rail, at the same height in
the top screw hole of the lowest 1/2” hole pattern, as shown in Figure
35 on page 81. The screws are used to support the chassis while you
secure it to the rack. Do not fully tighten these two screws at this time.
The screw heads should protrude from the rack approximately 6.4 mm
(.25 in).
311.1 mm (12.25“)
152.4 mm (6”0)
463.5 mm (18.25”)
Vista de pagina 79
1 2 ... 75 76 77 78 79 80 81 82 83 84 85 ... 221 222

Comentarios a estos manuales

Sin comentarios