Allied-telesis AT-S95 CLI Manual de usuario Pagina 204

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 392
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 203
Page 204
Allied Telesis
AT-S95 Management Software CLI Users Guide
power inline usage-threshold
The power inline usage-threshold Global Configuration mode command configures the threshold for initiating
inline power usage alarms. Use the no form of this command to return to the default configuration.
Syntax
power inline usage-threshold percentage [unit-number]
no power inline usage-threshold
Parameters
percentage Specifies the threshold as a percentage to compare measured power. (Range: 1 - 99)
unit-number — Specifies the current number of the unit. (Range: 1 - 6)
Default Configuration
The default threshold is 95 percent.
Command Mode
Global Configuration mode
User Guidelines
There are no user guidelines for this command.
Example
The following example configures the power usage threshold for which alarms are sent to 80%.
power inline traps enable
The power inline traps enable Global Configuration mode command enables inline power traps. Use the no
form of this command to disable inline power traps.
Syntax
power inline traps enable [unit-number]
no power inline traps enable
Parameters
unit-number — Specifies the current number of the unit. (Range: 1 - 6)
Default Configuration
Inline power traps are disabled.
Command Mode
Global Configuration mode
console(config)# power inline usage-threshold 80
Vista de pagina 203
1 2 ... 199 200 201 202 203 204 205 206 207 208 209 ... 391 392

Comentarios a estos manuales

Sin comentarios