Allied-telesis AT-S95 CLI Manual de usuario Pagina 105

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 392
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 104
Ethernet Configuration Commands
Page 105
Parameters
on — Force flow control as enabled.
off — Force flow control as disabled.
auto — Enable AUTO flow control configuration.
Default Configuration
Flow control is off.
Command Mode
Interface Configuration (Ethernet, port-channel) mode
User Guidelines
Negotiation should be enabled for flow control auto.
Example
In the following example, flow control is enabled on port 1/e5.
mdix
The mdix Interface Configuration (Ethernet) mode command enables cable crossover on a given interface. Use
the no form of this command to disable cable crossover.
Syntax
mdix {on | auto}
no mdix
Parameters
on — Manual mdix
auto — Automatic mdi/mdix
Default Configuration
The default setting is on.
Command Mode
Interface Configuration (Ethernet) mode
User Guidelines
Auto: All possibilities to connect a PC with cross or normal cables are supported and are automatically detected.
On: It is possible to connect to a PC only with a normal cable and to connect to another device only with a cross
cable.
No: It is possible to connect to a PC only with a cross cable and to connect to another device only with a normal
cable.
console(config)#
interface ethernet
1/e5
console(config-if)#
flowcontrol on
Vista de pagina 104
1 2 ... 100 101 102 103 104 105 106 107 108 109 110 ... 391 392

Comentarios a estos manuales

Sin comentarios