Allied-telesis AT-S95 CLI Manual de usuario Pagina 103

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 392
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 102
Ethernet Configuration Commands
Page 103
Command Mode
Interface Configuration (Ethernet, port-channel) mode
User Guidelines
The no speed command in a port-channel context returns each port in the port-channel to its maximum capability.
Example
The following example configures the speed operation of Ethernet port 1/e5 to 100 Mbps operation.
This document uses the following conventions to highlight important information:
Note
The speed setting for SFP ports is dependent on the maximum speed of the port.
duplex
The duplex Interface Configuration (Ethernet) mode command configures the full/half duplex operation of a given
Ethernet interface when not using auto-negotiation. Use the no form of this command to restore the default
configuration.
Syntax
duplex {half | full}
no duplex
Parameters
half — Forces half-duplex operation
full — Forces full-duplex operation
Default Configuration
The interface is set to full duplex.
Command Mode
Interface Configuration (Ethernet) mode
User Guidelines
When configuring a particular duplex mode on the port operating at 10/100 Mbps, disable the auto-negotiation on
that port.
Half duplex mode can be set only for ports operating at 10 Mbps or 100 Mbps.
console(config)#
interface ethernet
1/e5
console(config-if)#
speed 100
Vista de pagina 102
1 2 ... 98 99 100 101 102 103 104 105 106 107 108 ... 391 392

Comentarios a estos manuales

Sin comentarios