Allied-telesis AT-S63 Manual de usuario descargar pdf (Pagina 175)

100

101

AT-S63 Management Software Web Browser Interface User’s Guide

Section II: Advanced Features 175

The Configure RSTP Bridge Parameters tab is shown in Figure 57.

Figure 57. Configure RSTP Parameters Tab (Configuration)

5. Adjust the following parameters as necessary.

Force Version

This selection determines whether the bridge operates with RSTP

or in an STP-compatible mode. If you select RSTP, the bridge

operates all ports in RSTP, except for those ports that receive STP

BPDU packets. If you select Force STP Compatible, the bridge

operates in RSTP, using the RSTP parameter settings, but it sends

only STP BPDU packets out the ports.

Bridge Priority

The priority number for the bridge. This number is used in

determining the root bridge for RSTP. The bridge with the lowest

priority number is selected as the root bridge. If two or more

bridges have the same priority value, the bridge with the

numerically lowest MAC address becomes the root bridge. When

a root bridge goes off-line, the bridge with the next priority

number automatically takes over as the root bridge. This

parameter can be from 0 (zero) to 61,440 in increments of 4096,

with 0 being the highest priority. For a list of the increments, refer

to Table 5 on page 168.

1 2 ... 170 171 172 173 174 175 176 177 178 179 180 ... 387 388

Comentarios a estos manuales

Sin comentarios

Allied-telesis AT-S63 Manual de usuario Pagina 175

Comentarios a estos manuales

Relacionado con productos y manuales para Hardware De La Computadora Allied-telesis AT-S63