Allied-telesis AT-S25 Manual de usuario descargar pdf (Pagina 183)

AT-S25 Management Software User’s Guide

183

Transferring Files from a Local Management Interface

This section contains the procedure for downloading or uploading the

following files onto a switch from a local management interface.

❑ New AT-S25 image file

❑ Configuration file

You could transfer a file using Xmodem or TFTP. In order to use TFTP,

there must be a node on your network with the TFTP server software and

the file to download must be stored on the same node.

Caution

The switch will stop forwarding Ethernet traffic during the

download of the AT-S25 software image.

Note

Installing a new AT-S25 software image does not change the current

configuration of a switch (e.g., IP address, subnet mask, and virtual

LANs). To return a switch to its default configuration values, refer to

Returning the AT-S25 Software to the Factory Default Values on

page 55.

This procedure assumes that you have already obtained the new

software from Allied Telesyn and stored it on the management

workstation from which you will be performing the procedure, or on the

TFTP server.

To download a new software image or configuration file onto a switch,

perform the following procedure:

1. Establish a local management interface on the switch where you

intend to download the new management software or configuration

file.

For instructions, refer to Starting a Local or Telnet Management

Interface on page 34.

2. From the Main Menu, type 4 to select Administration Menu.

3. From the Administration Menu, type D to select Downloads & Uploads

Menu.

The Downloads & Uploads Menu in Figure 63 is displayed.

1 2 ... 178 179 180 181 182 183 184 185 186 187 188 ... 276 277

Sin comentarios

Allied-telesis AT-S25 Manual de usuario Pagina 183