Allied-telesis AlliedWare Plus Operating System Version 5.4.4C (x Manual de usuario descargar pdf (Pagina 159)

File Management Commands

Software Reference for x310 Series Switches

C613-50046-01 REV A AlliedWare Plus

Operating System - Version 5.4.4C 7.13

copy debug

This command copies a specified debug file to a destination file. Specify whether the

destination is Flash or Card when saving the software to the local filesystem.

This command copies a specified debug file to a destination file. Specify whether the

destination is Flash or USB when saving the software to the local filesystem.

Syntax copy debug {<destination-url>|card|debug|flash|nvs|scp|tftp|usb}

{<source-url>|card|debug|flash|nvs|scp|tftp|usb}

Mode

Privileged Exec

Example To copy debug output to an SD (or SDHC) card with a filename my-debug, use the

following command:

To copy debug output to a USB storage device with a filename my-debug, use the

following command:

Output Figure 7-2: CLI prompt after entering the copy debug command

Related Commands delete debug

move debug

Parameter Description

<destination-url> The URL where you would like the debug output saved. See

“URL Syntax and Keyword Usage” on page 7.3 for valid

URL syntax.

<source-url>

The URL where the debug output originates. See “URL

Syntax and Keyword Usage” on page 7.3 for valid URL

syntax.

awplus#

copy debug card:mydebug

awplus#

copy debug usb:mydebug

Enter source file name []:

1 2 ... 154 155 156 157 158 159 160 161 162 163 164 ... 221 222

Sin comentarios

Allied-telesis AlliedWare Plus Operating System Version 5.4.4C (x Manual de usuario Pagina 159