Allied-telesis AlliedWare Plus Operating System Version 5.4.4C (x Manual de usuario descargar pdf (Pagina 112)

User Access Commands

Software Reference for x310 Series Switches

5.26 AlliedWare Plus

Operating System - Version 5.4.4C C613-50046-01 REV A

service telnet

Use this command to enable the telnet server. The server is enabled by default. Enabling

the telnet server starts the switch listening for incoming telnet sessions on the configured

port.

The server listens on port 23, unless you have changed the port by using the privilege

level command on page 5.15.

Use the no variant of this command to disable the telnet server. Disabling the telnet server

will stop the switch listening for new incoming telnet sessions. However, existing telnet

sessions will still be active.

Syntax service telnet [ip|ipv6]

no service telnet [ip|ipv6]

Default

The IPv4 and IPv6 telnet servers are enabled by default.

The configured telnet port is TCP port 23 by default.

Mode Global Configuration

Examples To enable both the IPv4 and IPv6 telnet servers, use the following commands:

To enable the IPv6 telnet server only, use the following commands:

To disable both the IPv4 and IPv6 telnet servers, use the following commands:

To disable the IPv6 telnet server only, use the following commands:

Related Commands clear line vty

show telnet

telnet server

awplus#

configure terminal

awplus(config)#

service telnet

awplus#

configure terminal

awplus(config)#

service telnet ipv6

awplus#

configure terminal

awplus(config)#

no service telnet

awplus#

configure terminal

awplus(config)#

no service telnet ipv6

1 2 ... 107 108 109 110 111 112 113 114 115 116 117 ... 221 222

Sin comentarios

Allied-telesis AlliedWare Plus Operating System Version 5.4.4C (x Manual de usuario Pagina 112