Allied-telesis AT-S102 Manual de usuario descargar pdf (Pagina 162)

Chapter 6: Configuring the Media Converter Line Cards

162

AC (Continued)  Y for Yes - The auto-copy feature is activated on the slot. The

configuration settings for the AT-CM Line Card in the slot are

provided by the management card from the master configuration

file.

The AT-CM70S Line Card and the AT-CV Line Cards do not support

the auto-copy feature.

VER This column displays the version numbers of the management

software programs on the AT-CV5M02 Management Card and the

AT-CM Line Cards. This field may be blank for AT-CM Line Cards

that have a different version of AT-S73 Management Software than

the version of the management software on the management card.

This field will also be blank for AT-CV Line Cards because they do

not have management software.

FIBER PORT or COPPER PORT

ST This column displays the states of the ports. The possible states

are:

 * - The port has establish a link to a network device.

 o - The port has not establish a link to a network device.

SP This column displays the speeds of the ports. The possible speeds

are:

 10 - 10 Mbps

 100 - 100 Mbps

 1G - 1 Gbps

FC This column displays the status of flow control on the ports of the

AT-CM Line Cards. The possible states are:

 Y - Flow control is enabled on the port.

 N - Flow control is disabled on the port.

IngRL This column displays the settings of the ingress rate limiting filters

on the ports on the AT-CM Line Cards. The value “0” means rate

limiting has not been set on the port. This is the default setting. For

instructions on setting this parameter, refer to “Configuring the Port

Parameters on the AT-CM Line Cards” on page 169. This feature is

not supported on the AT-CV Line Cards.

Table 19. Module Status and Configuration Menu

Column Description

1 2 ... 157 158 159 160 161 162 163 164 165 166 167 ... 373 374

Sin comentarios

Allied-telesis AT-S102 Manual de usuario Pagina 162