Allied-telesis AT-S100 Manual de usuario Pagina 68

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 274
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 67
Chapter 2: Configuring the AT-S100 Software
68
switch(config)# interface ge18
switch(config-if)# user-priority 4
For more information about this command, see “USER-PRIORITY” on
page 193.
To assign a weight of 10 to queue 3, use the following commands:
switch# configure terminal
switch(config)# mls qos 0 0 0 0 0 0 10 0 0 0 0 0 0 0 0 0
Note
Repeat the MLS QOS command for each queue.
For more information about this command, see “MLS QOS” on page 143.
To set CoS mapping on port 12 with a user priority of 7 and a traffic class
of 8, enter the following commands:
switch# configure terminal
switch(config)# interface ge12
switch(config-if)# traffic-class-table user-priority 7
num-traffic-classes 8
For more information about this command, see “TRAFFIC-CLASS-TABLE
USER-PRIORITY NUM-TRAFFIC-CLASSES” on page 192.
Vista de pagina 67
1 2 ... 63 64 65 66 67 68 69 70 71 72 73 ... 273 274

Comentarios a estos manuales

Sin comentarios