Allied-telesis AT-S100 Manual de usuario descargar pdf (Pagina 45)

AT-S100 Management Software User’s Guide

Enabling and

Disabling Ports

To enable or disable a port on the switch, use the SHUTDOWN command.

The syntax of this command is:

shutdown|no shutdown

To enable port 12, enter the following commands:

switch# configure terminal

switch(config)# interface ge12

switch(config-if)# shutdown

To disable port 19, enter the following commands:

switch# configure terminal

switch(config)# interface ge19

switch(config-if)# no shutdown

For more information about this command, see “SHUTDOWN” on

page 181.

Setting MDI and

MDIX

The twisted pair ports on the switch feature auto-MDI and MDIX. This

feature, available when a port’s speed and duplex mode are set through

Auto-Negotiation, configures a switch port to MDI or MDIX automatically,

depending on the wiring configuration of the port on the end node. This

feature allows you to connect any network device to a port on the switch

using a straight-through twisted pair cable.

If Auto-Negotiation is disabled on a port and the speed and duplex mode

are set manually, the auto-MDI/MDI-X feature is also disabled and the

port’s wiring configuration defaults to the MDI-X setting. This setting can

be configured with the AT-S100 Management Software.

The syntax of this command is:

mdix mdi|mdix

To set a port to MDI, enter the following commands:

switch# configure terminal

switch(config)# interface ge12

switch(config-if)# mdix mdi

1 2 ... 40 41 42 43 44 45 46 47 48 49 50 ... 273 274

Sin comentarios

Allied-telesis AT-S100 Manual de usuario Pagina 45