Allied-telesis AT-S100 Manual de usuario descargar pdf (Pagina 16)

Chapter 1: Getting Started with the Command Line Interface

Introducing the Command Modes

This chapter describes the CLI command modes and how to access the

command line interface. There are 5 command modes:

 Privileged Executive

 Configuration Terminal

 VLAN Configuration

 Interface Configuration

 Line

In the AT-S100 software, the commands are accessed through a

hierarchy of command modes. Each command mode contains a subset of

commands that are available within that mode. See Figure 1 on page 17

for an illustration of the command modes.

When you log on to the CLI interface, the default command mode that you

access depends on your login id. There are two default login ids that are

sent from the factory. The operator login id enables you to display

information about the software configuration. With this login, you access

the View command mode automatically. The manager login id permits full

administrator capabilities. With this login, you access the Privileged

Executive mode by default.

You enter a specific command to navigate from one command mode to

another. For example, to access the Configuration Terminal mode, enter

the CONFIGURE TERMINAL command from the Privileged Executive

mode. Once you enter a new command mode, the AT-S100 prompt

changes to indicate the new mode.

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 273 274

Sin comentarios

Allied-telesis AT-S100 Manual de usuario Pagina 16