Allied-telesis AT-FS716L Manual de usuario descargar pdf (Pagina 32)

Chapter 2: Installation

Cabling the Switch

To connect the twisted pair cables to the ports on the AT-FS716L switch,

perform the following procedure:

1. Connect the twisted pair data cables to the RJ-45 ports on the switch,

as shown in Figure 10.

Figure 10. Connecting the Twisted Pair Data Cables

When connecting a twisted pair cable to a port, observe the following

guidelines:

 An RJ-45 connector should fit snugly into the port on the switch.

The tab on the connector should lock the connector into place.

 The ports on the switch are auto-MDI/MDI-X. You can use a

straight-through twisted pair cable to connect any type of network

device to a port on the switch.

 The network should not contain data loops, which can adversely

affect network performance. A data loop exists when two or more

network devices can communicate with each other over more than

one data path.

3 5 7 9 11 13 15

4 6 810 12 14

1013

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 61 62

Sin comentarios

Allied-telesis AT-FS716L Manual de usuario Pagina 32