Allied-telesis AT-FS716L Manual de usuario Pagina 28

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 62
  • Tabla de contenidos
  • SOLUCIÓN DE PROBLEMAS
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 27
Chapter 2: Installation
28
Warning
Power cord is used as a disconnection device: To de-energize
equipment, disconnect the power cord. 5
6. Verify that the POWER LED is green. If the LED is OFF, refer to
“Troubleshooting” on page 34 for instructions.
Note
The switch perform a self-diagnostic test upon power up. This takes
about 20 seconds to complete.
7. Power ON the end-nodes connected to the switch.
8. Check that all the L/A LEDs are either green or orange. If any of the
LEDs is OFF, refer to “Troubleshooting” on page 34 for instructions.
The switch is now ready for use.
Vista de pagina 27
1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 61 62

Comentarios a estos manuales

Sin comentarios