Allied Telesis AR450S Manual de usuario descargar pdf (Pagina 35)

Switching on the AR440S, AR441S and AR450S SHOW SWITCH 3-35

Software Release 2.6.6

C613-03079-00 REV A

SET VLAN PORT

Syntax SET VLAN={vlan-name|1..4094} PORT={port-list|ALL}

FRAME={UNTAGGED|TAGGED}

where:

■ vlan-name is a unique name for the VLAN 1 to 15 characters long. Valid

characters are uppercase and lowercase letters, digits (0-9), the underscore

character (“_”), and the hyphen ( - ). The vlan-name cannot be a number or

ALL.

■ port-list is a port number, a range of port numbers (specified as n-m), or a

comma separated list of port numbers and/or ranges. Port numbers start

at 1 and end at m, where m is the highest numbered Ethernet port.

Description This command changes the status of ports in a VLAN from tagged to untagged

or vice-versa.

The VLAN parameter specifies the name of the VLAN or the numerical VLAN

Identifier of the VLAN. The name is not case sensitive although the case is

preserved for display purposes. The VLAN specified must exist.

The PORT parameter specifies the port(s) to be changed. The ports must belong

to the specified VLAN. If the command would succeed on a subset of the ports

specified, but cause an error on the others, then the command as a whole fails

and has no effect. If ALL is specified, then all ports in the VLAN change.

The FRAME parameter specifies whether packets transmitted from a port for

the specified VLAN include a VLAN tag header. If FRAME is set to

UNTAGGED, the port becomes an untagged port for the specified VLAN.

FRAME must be set to UNTAGGED if the port was previously tagged in the

same VLAN, and is not an UNTAGGED port of another VLAN. If FRAME is

set to TAGGED, then the port becomes a tagged port for the specified VLAN.

FRAME may be set to TAGGED only if the ports were previously untagged

ports in the same VLAN.

Example To change the status of port 1 of the default VLAN from untagged to tagged,

use the command:

SET VLAN=DEFAULT PORT=1 FRAME=TAGGED

Related Commands ADD VLAN PORT

DELETE VLAN PORT

SHOW VLAN

SHOW SWITCH

Syntax SHOW SWITCH

Description This command displays configuration information for the switch functions (see

Figure 3-7 on page 3-36 and Table 3-13 on page 3-36).

1 2 ... 30 31 32 33 34 35 36 37 38 39 40 ... 47 48

Sin comentarios

Allied Telesis AR450S Manual de usuario Pagina 35