Allied Telesis AT-2450 Series Guía de instalación descargar pdf (Pagina 28)

AT-2450 PCI Ethernet Adapter Card

Running CardAssistant in DOS Command-Line Mode

When you wish to prepare and configure several AT-2450 PCI

Ethernet Adapter Card cards for users in an assembly-line

approach, you can either use configuration parameters in the

command line or you can write a file that invokes CardAssistant

when read. The syntax for running CardAssistant in command-

line mode (from DOS) is as follows:

setup24 [

parameters

]

where parameters is replaced with the parameters you wish to

modify from their default values. If you intend to use the default

value for a parameter, it may be omitted.

Table 4 lists the parameters that may be set.

The

/X parameter is a specialized switch that tells CardAssistant

to perform diagnostic checks on the AT-2450 PCI Ethernet

Adapter Card installed in the computer instead of executing the

setup program. This switch should be used on its own (i.e.,

without specifying other parameters) and with no driver loaded.

Table 4: Command-Line Mode Parameter Names

Parameter Function

/p =

port

port = UTP, BNC, AUI, FIBER port, or

AUTO

performs diagnostics

/d =

mode

mode = full or half-duplex (default)

/W =

filename

writes configuration file

filename

reads configuration file

2450T IG.bk Page 22 Tuesday, December 29, 1998 11:58 AM

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 63 64

Sin comentarios

Allied Telesis AT-2450 Series Guía de instalación Pagina 28