Allied Telesis AT-2450 Series Guía de instalación descargar pdf (Pagina 26)

AT-2450 PCI Ethernet Adapter Card

Your computer’s PCI BIOS assigns values for the I/O

parameters shown (Base I/O, Interrupt) to avoid conflicts. In

CardAssistant these values are read-only. For more information

about I/O conflicts, refer to your computer’s documentation on

PCI setup, CMOS setup, or ISA Configuration Utility (ICU).

Changing media selection (AT-2450BT and -FT). The AT-2450BT

and -FT adapter cards are configured to automatically sense

which port is connected. For most applications, there is no need

to change this. You can simply connect a media cable to one port

or the other. It is possible, however, to manually set the card to a

particular port.

1. Select the Port Selection field using the arrow keys or

mouse and press

2. Select the media choice and press .

3. If you are running CardAssistant from DOS, press to

save the change. If you are running CardAssistant from 32-

bit Windows, select the Save Configuration button.

Full Duplex Operation. By default the card works in half duplex

mode. In this mode, the card can at a given time either send or

receive data, but not both. Selecting full duplex enables the card

to send and receive simultaneously. Full duplex operation is only

effective if a full-duplex hub is at the other end of the Ethernet

segment.

1. In the configuration window, select Full Duplex. If you are

running CardAssistant from DOS, press to reveal

the duplex mode choices.

2. If you are running CardAssistant from DOS, press to

save the change. If you are running CardAssistant from 32-

bit Windows, select the Save Configuration button.

ENTER

F10

ENTER

F10

2450T IG.bk Page 20 Tuesday, December 29, 1998 11:58 AM

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 63 64

Sin comentarios

Allied Telesis AT-2450 Series Guía de instalación Pagina 26