Allied Telesis AT-FS705LE Guía de instalación descargar pdf (Pagina 29)

AT-FS705LE Installation Guide

15

5. Plug the AC/DC power adapter into an

appropriate AC power outlet and insert the

power plug into the DC receptacle located on

the front of the switch.

6. Make sure the PWR LED, is green. If the

LED is OFF, refer to “Troubleshooting” on

page 16.

7. Attach the data cables to the switch ports. Do

not use a crossover cable to connect

workstations or servers to ports 1 through 5.

Do not use a crossover cable to connect

another AT-FS705LE switch to the Uplink

port.

Note

You can use either Port 5 or the Uplink

port, but you cannot use both

simultaneously.

8. Power ON the end-nodes.

9. Check that the LINK/ACT LEDs for each port

on the switch are green. If the LEDs are OFF,

refer to “Troubleshooting” on page 16 for

instructions.

The switch is now ready for use.

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 45 46

Comentarios a estos manuales

Sin comentarios