Allied Telesis AT-FS705LE Guía de instalación descargar pdf (Pagina 28)

Installing the Switch on a Wall

For wall-mount installation, you can position

the switch vertically or horizontally using the

keyhole cutouts in the bottom of the switch.

1. If previously attached, remove the rubber

feet, data cables, and the DC power cord from

the switch.

2. Select a wall location for the switch.

Note

For wall-mount installation, the screws,

plastic anchors, and any other material

necessary to physically mount the switch

to the wall are not provided.

3. Install two plastic anchors and two pan-head

screws into the wall, separated by 5

centimeters (approximately 2 inches).

4. Position the switch onto the wall screws.

Warning

The power cord is used as a

disconnection device. To de-energize

equipment, disconnect the power cord.

$ 5

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 45 46

Sin comentarios

Allied Telesis AT-FS705LE Guía de instalación Pagina 28