
Chapter 7: Powering On the Stack
98
Figure 47. Returning to the Privileged Exec Mode
4. Enter the WRITE command to save your change in the configuration
file. The switch displays the confirmation prompt in Figure 48.
Figure 48. Saving the Priority Values with the WRITE Command
5. To end the management session, enter the EXIT command.
6. Go to Chapter 8, “Cabling the Networking Ports” on page 103, to
continue with the installation.
awplus(config)# exit
awplus#
awplus# write
Building configuration ...
[OK]
awplus#
Comentarios a estos manuales