Allied-telesis AT-S62 Manual de usuario Pagina 622

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 656
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 621
Chapter 36: Secure Shell (SSH) Commands
622 Section VII: Management Security
SET SSH SERVER
Syntax
set ssh server hostkey=
key-id
serverkey=
key-id
[expirytime=
hours
] [logintimeout=
seconds
]
Parameters
hostkey Specifies the ID number of the encryption key pair to
function as the host key.
serverkey Specifies the ID number of the encryption key pair to
function as the server key.
expirytime Specifies the length of time, in hours, after which the
server key pair is regenerated. The range is 0 to 5
hours. Entering 0 never regenerates the key. The
default is 0.
logintimeout Specifies the length of time the server waits before
disconnecting an un-authenticated client. The range is
60 to 600 and the default is 180.
Description
This command modifies the configuration of the Secure Shell server
parameters.
The HOSTKEY parameter specifies the key ID of the host key pair. The
specified key pair must already exist. To create a key pair, refer to
“CREATE ENCO KEY” on page 590 (syntax 1).
The SERVERKEY parameter specifies the key of the server key pair. The
specified key pair must already exist.
The EXPIRYTIME parameter specifies the time, in hours, after which the
Secure Shell server key will expire and will be regenerated. If 0 is
specified the key does not expire. The range is 0 to 5 and the default is 0.
The LOGINTIMEOUT parameter specifies the length of time the server
waits before disconnecting an un-authenticated client. The range is 60 to
600 seconds. The default is 180 seconds.
Example
The following command sets the Secure Shell server key expiry time to 1
hour:
set ssh server expirytime=1
Vista de pagina 621
1 2 ... 617 618 619 620 621 622 623 624 625 626 627 ... 655 656

Comentarios a estos manuales

Sin comentarios