
PowerBlade PBC18 Installation Guide
53
BNC
Termination
Switch
(AT-PB15 only)
The BNC Termination switch on the AT-PB15 offers 50 Ω termination
without the use of a T-connector and 50 Ω barrel terminator. Only end-
point nodes need 50 Ω termination. Internal nodes on a thinnet
segment should be connected to the cable through standard 10Base2
T-connectors. Figure 22 shows the location of the BNC Termination
switch on the AT-PB15.
Figure 22 BNC Termination Switch
BNC TERMINATION
SWITCH
ON OFF
SW2
BNC TERMINATION
SWITCH
ON OFF
SW2
Comentarios a estos manuales