Allied-telesis AT-FS970M Series Manual de usuario descargar pdf (Pagina 160)

Chapter 8: Basic Switch Management Commands

160

REBOOT

Syntax

reboot

Parameters

None

Mode

Privileged Exec mode

Description

Use this command to reset the switch. You might reset the unit if it is

experiencing a problem or if you want to reconfigure its settings after you

designate a new active boot configuration file.This command is identical to

“RELOAD” on page 161. The command displays a confirmation prompt.

Caution

The switch does not forward network traffic while it initializes its

management software. Some network traffic may be lost. The reset

can take from 10 seconds to two minutes, depending on the number

and complexity of the commands in the active boot configuration file.

Note

The switch discards any configuration changes that have not been

saved in its active boot configuration file. To save your changes,

enter the WRITE command or the COPY RUNNING-CONFIG

STARTUP-CONFIG command before resetting the switch. For

instructions, refer to “WRITE” on page 108 or “COPY RUNNING-

CONFIG STARTUP-CONFIG” on page 97.

To resume managing the switch, wait for the switch to initialize the

management software and then start a new management session.

Example

The following command resets the switch:

awplus> enable

awplus# reboot

Are you sure you want to reboot the switch? (y/n): y

1 2 ... 155 156 157 158 159 160 161 162 163 164 165 ... 192 193

Sin comentarios

Allied-telesis AT-FS970M Series Manual de usuario Pagina 160