Allied-telesis AT-FS970M Series Manual de usuario descargar pdf (Pagina 150)

Chapter 8: Basic Switch Management Commands

150

EXEC-TIMEOUT

Syntax

exec-timeout

value

Parameters

exec-timeout

Specifies the session timer in minutes. The range is 0 to 35,791

minutes. The default value is 10 minutes.

Mode

Line Console and Virtual Terminal Line modes

Description

Use this command to set the management session timers. The timers are

used by the switch to end inactive management sessions to protect

against unauthorized changes should you leave your management station

unattended during a management session. A management session is

deemed inactive by the switch if there is no management activity for the

duration of a timer.

Local management sessions, which are conducted through the Console

port on the switch, and remote Telnet and SSH sessions have different

timers. The timer for local management sessions is set in the Line Console

mode. The timers for remote Telnet and SSH sessions are set in the

Virtual Terminal Line mode. There is a different timer for each of the ten

VTY lines for remote Telnet and SSH sessions.

Confirmation Commands

“SHOW SWITCH” on page 167 and “SHOW RUNNING-CONFIG” on

page 166

Examples

This example sets the session timer for local management sessions to 15

minutes:

awplus> enable

awplus# configure terminal

awplus(config)# line console 0

awplus(config-line)# exec-timeout 15

1 2 ... 145 146 147 148 149 150 151 152 153 154 155 ... 192 193

Sin comentarios

Allied-telesis AT-FS970M Series Manual de usuario Pagina 150