Allied-telesis AT-9448Ts/XP (Basic Layer 3) Manual de usuario descargar pdf (Pagina 52)

Chapter 2: Installing the Switch

Installing the Switch in a Rack

Perform the following procedure to install the switch in a standard 19-inch

rack:

Note

Steps 1, 2, and 3 are optional. They remove the snap-on plastic feet

from the bottom of a switch. The feet can be left on.

1. Place the unit upside down on a level, secure surface.

2. Using a flat-head screwdriver, remove the snap-on plastic feet from

the bottom of the switch, as shown in Figure 17.

Figure 17. Removing the Feet

3. Turn the switch over.

4. Attach a rack-mount bracket to one side of the switch using four of the

screws that come with the switch, as shown in Figure 18.

Figure 18. Attaching Rack-Mount Brackets

1 2 ... 47 48 49 50 51 52 53 54 55 56 57 ... 81 82

Sin comentarios

Allied-telesis AT-9448Ts/XP (Basic Layer 3) Manual de usuario Pagina 52